mini shredder automatic control module code

If you want to modify the current parameters when the trigger generator reverses, please follow the steps below. 1.Download and install Arduino IDE. https://www.arduino.cc/en/software
2.Connect the USB cable of the control module to the computer.
3.Download and open source code（2024-07）
Relay Version:
https://drive.google.com/file/d/19rfr7pA1hTSKb4X1sW_HTsDY7zU8Lf7S/view?usp=sharing
IBT_2/BTS7960 version：
https://drive.google.com/file/d/1qPhi_lP-vR9iKEqJ326wAOmAN4QIBQty/view?usp=sharing

4.Set up Arduino IDE as shown below.

The port numbers shown here are different for each computer, so please try it yourself.

If you wait for a long time when uploading the code and it is not completed, try disconnecting the USB connection, then switch the options shown in the picture, and then reconnect the USB. Uploading the code should complete within 3 seconds.
**Please close the Serial Monitor window before uploading, otherwise the code upload will fail.**

Warning, if you want to modify the circuit, please cut off the power supply and check the circuit several times to see if it is correct. Any wrong wiring will kill the nano chip immediately.

If you need more help, you can contact me:
[email protected]